Vitek VT-3496 Guida Utente Scaricare il pdf (Pagina 45)

VT-HDOC Series

ALARM OUT : You can select Relay to be configure

OPERATION: You can configure output status of Relay.

 DISABLE: Relay is not working

 ENABLE: Relay is working once event is triggered.

MODE: You can configure activation of Relay output.

 TRANSPARENT: Keep Relay output until event triggering stopped.

 LATCHED: Keep relay output for duration time from the event triggered lately.

DURATION: If the alarm output mode is configured as Latched. You can configure

duration time for relay output.

TYPE : Define the transition of the signal of Alarm output

 N/O (Active Low): When event triggered, the relay will go to ‘Close’ state from ‘Open’.

 N/C(Active High): When event triggered, the relay will go to ‘Open’ state from ‘Close’

HDD EVENT: If you select “ON”, when HDD related Event is triggered, relay will trigger

ALARM: When sensor input, relay output will trigger.

VIDEO LOSS: When video loss occurs, replay output will trigger.

MOTION: When motion triggered, replay output will trigger.

6.5.3 BUZZER OUTPUT SETUP

OPERATION: You can configure the output status of Buzzer.

 DISABLE: Buzzer is not working when event is triggered.

 ENABLE: Buzzer is working when event triggered.

HDD EVENT: If HDD related event is triggered, Buzzer output will trigger.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 95 96

Nessun commento

Vitek VT-3496 Guida Utente Pagina 45